WEEK 6
DO THE CODING AND RUN THE SENSOR
On this week , i have do the coding on my microcontroller which is on Arduino UNO. In this task , i have succeed to run a coding and display the result on the Serial Monitor. But, i have a problem with my ESP 8266 which cannot connect to my Arduino UNO due to the RX and TX does not enough pin on my microcontroller.
ACTIVITY :
1) Run the coding
I manage to connect my Arduino UNO with the MQ 135 sensor and GPS Module. I can display the result on the Serial Monitor without any problem.
ACTIVITY :
1) Run the coding
I manage to connect my Arduino UNO with the MQ 135 sensor and GPS Module. I can display the result on the Serial Monitor without any problem.
2) Problem with ESP 8266 Wifi Module
I have a problem with my ESP 8266 Wifi Module because it is cannot connect to the phone due to the GPS Module has using one RX and TX on it. It is because the Arduino UNO does not have two of RX and TX. Thankfully, i have the solution which is i can change the microcontroller to NODEMCU ESP8266.
SUMMARY
I have success to get the output result but due to certain problem occur on my Wifi Shield, i have to buy new microcontroller which is NODEMCU ESP8266.
0 comments